Replace Bonnet Scoop
06/10/2007
Fitted a C1 Bonnet Scoop. Ordered on eBay, delivered on 28/08/2007. I primed, painted and laquered this over 2 weeks. Paint code for Chilli Red is 3P0. I also placed mesh inside for both appearance and protection.
Instructions on how replace the bonnet scoop:
1. Open bonnet
2. There are 4 holes underneath the area of the scoop. These each contain a 10mm nut which the scoop is bolted through. Undo these nuts carefully. Take special care not to drop these nuts into the engine, or into the inside cavity of the bonnet. I usually place a sheet or towel over the engine bay just in case.
3. Once all 4 have been
taken out, close the bonnet and give the scoop a tug. It is clipped in centrally, but a sharp pull should release it without problems.